LED ramp with reflector technology in a slim design. The reflector's optics concentrate light on areas where the vehicle's normal lighting is not sufficient. The light pattern is wide and flat, just like the road, thus minimizing light loss up in the air and down into the nearby road surface, which in wet asphalt can otherwise give dazzling reflections. For maximum durability, the lens is made of polycarbonate.

Technical data:
Voltage: 9–36 V
Diodes: 12 x 3 W
Theoretical lumens: 3240 lm
Actual lumens: 2430–2590 lm
Power consumption: 36 W
Dimensions (wxhxd): 185/350 x 38 x 64 mm
Cable length: 50 cm deutschkontakt male + 50 cm deutschkontakt female
IP class: 68 Other: E-approved according to ECE-R10 and R112.

Through PWM (Pulse Width Modulation) technology, the LEDs are switched on and off at a frequency so high that the eye does not have time to register a flicker. This technology is used both to be able to drive the diodes harder with a lower heat generation and to act as a power-regulating electronic protection when the lamp is at risk of getting too hot. This increases the performance of the lamp and extends its lifespan.